DBM13 3000W Peak/750W RMS Mono Amplifier for Boat Subwoofers, 2 Ohm, Weather-Resistant, Bass Remote, High-Performance Audio

Description:

We went a little overboard (no pun intended) to make this amp marine ready. We conformal coated the PCB board with a waterproof glue that is painted on to protect the circuitry. We then added waterproof silicone covers over the terminals so that water can never get into the amp. The heat sink, including the bottom plate, is made of aluminum which is rustproof. The end panels, all of the internal mounting screws and hardware of the amp are made of stainless steel and are rustproof as well. Even after many years of use the amp will be rust free and operate like new! The dBM13 is a mono amplifier with 3,000 watts peak output and 750 watts certified RMS dyno-tested rated power at less than 1% THD. Here at Rockville we offer the best value in marine audio. We therefore want to make it easy for you to compare our products to any brands on the market. The peak rating can be used to compare with brands who use peak ratings such as Boss and Power Acoustik while the Dyno Certified RMS rating can be used to compare with top brands such as Kicker, Rockford, Alpine, etc.

_________________________________________________________________________________________________________________________________________________________________

Features:

• Rockville DBM13 3000 Watt Peak/750w Dyno-Certified RMS Mono Marine Amplifier 2 Ohm Amp+Remote
• Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc)
• 2 Ohm: 750 Watts x 1 Channel
• 4 Ohm: 450 Watts x 1 Channel
• Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc)
• 2 Ohm: 3000 Watts x 1 Channel
• 4 Ohm: 1800 Watts x 1 Channel
• Fully Adjustable 12dB / Octave Crossover with Differential Circuitry
• Adjustable Low Pass Filter: 50Hz - 250Hz
• Adjustable Subsonic Filter: 15Hz - 55Hz
• Adjustable Input Level Control
• Fully Adjustable 12dB Bass Equalizer
• Minimum THD at Rated Power: <0.1%
• S/N Ratio: >90 dB
• Frequency Response: 15Hz - 250Hz
• Damping Factor: >150 @ 100Hz
• 80 Amp Maxi Fuse
• Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue)
• Waterproof silicone covers for end panels
• Rustproof Aluminum heatsink with white painted finish
• Stainless steel end panels are rustproof
• All screws and mounting hardware are stainless steel and rustproof
• Bottom panel is aluminum and rustproof
• High-Speed MOSFET Power Supply
• Class “D” power supply
• Phase Control Switch
• Mute and Delay Soft Start System
• RCA Preamp Line Output
• RCA Input